warning

you have to make sure that your age is 18 or older, then you can browse this website further. otherwise, please leave and close this page immediately !

Tobacco Heating products

News

home |News |

Use and Cleaning Diagram of Mysmok ISMOD I New Heating Non-combustion E-cigarette Starter Kit

categories

latest news

latest news

Tobacco Revolution: Pan For Gold in A 700 Billion Dollars Market Tobacco Revolution: Pan For Gold in A 700 Billion Dollars Market

Traditional tobacco——the sole Commodity in the world which does us no good while legalized for sales globally,there is nothing in the world so contrad

Use and Cleaning Diagram of Mysmok ISMOD I New Heating Non-combustion E-cigarette Starter Kit

  • 2018-08-13

Charging cable: original authentic charging cable to ensure stable device charging

Cleaning brush: effective stains cleaning, handle design, convenient and handy

Cleaning blade: Effectively eradicating stubborn residues

Cleaning swabs: low-purity alcohol sticks, effectively cleaning the inside of the holder. Gentle wipe is needed in case of breaking the heater.

When inserting the heat stick into Mysmok iSMOD I, put it directly inside without turning it, and also do not turn it while pulling it out. Otherwise the heater may be damaged.

Charging method:

1. Insert the charging cable into the bottom connector and connect to the power supply

2. During charging, the indicator light is red and steadily on.

3. The indicator light turns blue when fully charged.


Instructions:



1. Insert a special heat stick gently

2. Make it into the position as shown in Figure 2

3. Press the power button for about 3-5 seconds, then the blue light will flashes for about 10 seconds; when the light stops flashing and goes solid on, the heating is completed and you can start smoking

4. There will be 15 seconds of preheating, and each heat stick allows 210 seconds or 13-15 puffs of smoking.

5. When inserting the heat stick, put it directly inside without turning it, and also do not turn it while pulling it out. Be careful not to damage the heat blade.



Remove cigarettes:


1. Loosen the cap first and slowly slide forward

2. Remove the cap completely before removing the heat stick

3. The discoloration in some positions of the used heat stick is normal and the used heat sticks are treated as normal household waste.

Cleaning products

1. Use a cleaning blade to remove smoke stains in a gentle way until full eradication of residues.

2. Use a cleaning brush: turn the handle around to clean.

1. Take out the low purity clean alcohol stick

2. Break one end of the swab with a blue circle mark so that alcohol will flow down the pipe to the other end

3. Use the swab to gently wipe the heater and the protective tube

The above is the use and cleaning process of Mysmok iSMOD I. Be careful when using it.

friendly links :

mysmokchina.en.alibaba.com

copyright © 2019 Mysmok Electronic Technology Co., Ltd.all rights reserved.

#

   

the professional team to service !

chat now

live chat

    If you have questions or suggestions,please leave us a message,we will reply you as soon as we can!